Underwriters Laboratories Network IR Speed Dome Camera Instrukcja Instalacji Pobierz pdf (Strona 8)

IR Speed Dome Installation Manual

Figure 1.2.4 Screw up the lock screws

3. Take out the speed dome and tear off the protective sticker from it, as shown in figure 1.2.5. Configure the address, baud rate and

other parameters through DIP switch SW1 and SW2 located on the bottom board of the dome, as shown in Figure 1.2.3(the bottom

board of IR speed dome), Figure 1.2.4(the bottom board of network IR speed dome) and Figure 1.2.5(the bottom board of network

high-definition IR speed dome). Please refer to Section 1.4 DIP Switch Settings for specific settings about address, baud rate,

communication protocol, etc.

Note: There is only the matched resistance DIP switch of RS-485 on the bottom board of network high-definition IR speed dome. The

RS-485 parameter of network high-definition IR speed dome should be configured in the OSD menu or on ‘Remote Settings’ page in

the client software.

Figure 1.2.5 Tear off the protective sticker

Protective sticker

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Brak uwag

Underwriters Laboratories Network IR Speed Dome Camera Instrukcja Instalacji Strona 8