Underwriters Laboratories Network IR Speed Dome Camera Instrukcja Instalacji Pobierz pdf (Strona 16)

IR Speed Dome Installation Manual

1.4 DIP Switch Settings

Note: The parameters of 485 serial port of network high-definition IR speed dome must be configured in OSD menu, on ‘Remote

Setting’ page through client software or in ‘Remote Setting’ page through IE browser.

1.4.1 DIP Switch Settings for IR Speed Dome and Network IR Speed Dome

Figure. 1.4.1 Bottom board of IR speed dome

The dome provides two DIP switches SW1 and SW2 for setting the dome address, baud rate, protocol, etc (As shown in Figure

1.4.1, ON=1, OFF=0). In SW1 and SW2, 1 is the lowest position and 8 is the highest position.

Note: As the IR speed dome is capable of being self-adaptive to PELCO-D, PELCO-P, HIK-Code, VICON and KALATEL-32

protocols, and the network IR speed dome is self-adaptive to PELCO-P, PELCO-D and HIK-Code protocols as well, so, there are no

1 2

1. Address DIP Switch

2. Protocol DIP Switch

3. Address and Protocol Settings

4. Grounding screw

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Brak uwag

Underwriters Laboratories Network IR Speed Dome Camera Instrukcja Instalacji Strona 16